Natimur Sahara

Recommendations and specifications

Installation surfaces: Plaster, plasterboard, bricks, concrete, concrete bricks, plastered/rendered surfaces, wood, ceramic tiles, depending on the specifications of the used adhesive. The surface on which the product is installed must be in good condition, dry, dust free, stable, and protected against water infiltration.
Exceptions: The product should not be installed on floors or ceilings.
The back of the tiles must be dry and free of dust, oils, or other non-stick surfaces.
The colour of the natural stone may vary.

Product storage

The product must be stored in covered spaces that are protected from humidity or precipitation.

Installation instructions

1. Draw level lines.
2. Preselect the decorative tiles and mix them from different boxes.
3. Smooth the edges and brush the back of the decorative tiles for better adhesion.
4. Cut the tiles to the desired size, if necessary.
5. Apply the adequate adhesive for the support, on both the installation surface and the back of the tiles.
6. Apply the decorative tiles to the wall.
7. Optionally, apply the protective spray to the entire surface of the installed decorative tiles.

Maintenance

• Use only PH-neutral detergent solutions for cleaning the tiles.
• Clean the tiles with a vacuum cleaner but avoid direct contact of the nozzle with the wall cladding.
• Do not clean the tiles with high-pressure devices. Otherwise, you may risk damaging them.
• For deep stains, seek professional advice. Avoid using non-specific cleaning products.
• Consult the producer’s product range for specific cleaning and protection solutions.